|
| |
Carpentry IV
 |
Carpentry IVA
 | 27401-03 Site Layout Two: Angular Measurement
Covers the principles, equipment, and methods used to perform the site
layout tasks that require making angular measurements. Tasks include laying
out building foundation lines and determining elevations by trigonometric
leveling. The use of laser instruments, transits, theodolites, electronic
distance measurement, and total stations are covered. Reviews trade
mathematics, including geometry and right-angle trigonometry, needed to
perform the calculations related to angular measurements. |
| 27402-03 Advanced Roof Systems
Covers commercial roofing materials and structures and describes the
procedures for installing commercial roofing such as standing seam, lap
seam, and built-up roofs. |
| 27403-03 Advanced Floor Systems
Covers structural and lightweight concrete floors, in-floor radiant heating,
and a variety of finish flooring, including hardwood floors, vinyl tile,
carpeting, and terra cotta tile. |
|
|
Carpentry IVB
| 27404-03 Advanced Wall Systems
Covers installation of a variety of finishing materials, including paneling,
wainscoting, and movable partitions. Also covers installation of curtain
walls and fire-rated commercial construction. |
| 27405-03 Advanced Stair Systems
Provides extensive coverage of the materials and techniques used in
finishing wooden staircases. Also covers a variety of stair systems used in
commercial construction. |
| 27406-03 Introduction to Light Equipment
This module introduces the trainees to various pieces of light construction
equipment commonly used at a construction site, including the aerial lift,
skid steer loader, trencher, electric power generator, compressor,
compactor, and forklift. An overview of general safety, operation, and
maintenance procedures is given for each type of
equipment covered. |
|
|
Carpentry IVC
| 27407-03 Welding
The trainee is introduced to the equipment, procedures, and safety practices
used in cutting steel with oxyfuel equipment and in shielded metal arc
welding. Labs include practice in cutting and welding techniques. |
| 27408-03 Metal Buildings
The trainee is introduced to the basic structural components, fastening
methods, and assembly techniques for metal buildings. An overview of the
materials and practices used in the application of roofs, wall panels,
windows, doors, trim, and flashing is also provided. |
| 27409-03 Introductory Skills for the Crew Leader
Along with the principles of project planning, scheduling, estimating, and
management, the trainee learns the basic skills required supervising
personnel. Several case studies are included. |
|
|
